Notice about FENG3's Homepage URL change

This site may be stopped on March 15, 2012.

New URL is http://feng3.nobody.jp/en/

Please change bookmarks on your browser.

If you are not redirected automatically within a few seconds then please click on the link below.

Click here to move to the New Site.

FENG3's Homepage

Welcome to the Homepage of FENG3 !
FENG3 is a beginner of hobby electronics. This page contains some information about my project. I will be glad if this page is useful for you.

PIC Programmer Project

Reprogramming becomes impossible to small PIC !

RCD Programmer
Updated !

NEW !
Ukrainian version is available now!
PICProg4U
PIC programming software for RCD Programmer(by FENG3). This software requires .NET Framework 1.1 or later.

Multi PIC Programmer(JDM Programmer)

New Version
Old Version
VPP before VDD
VPP during VDD

NEW !

Device Positions for Multi PIC Programmer 5V2 (added: 2006-07-16 JST)
PICProg4U supports Ukrainian now (updated: 2006-06-19 JST)
PICProg4U supports your JDM Programmer(Multi PIC Programmer) now (updated: 2006-05-13 JST)
PICProg4U, the PIC programming software for your RCD Programmer (updated: 2006-04-03 JST)
The trick of programming PIC12F508/509 using IC-Prog(modified: 2005-11-11 JST)
PIC12F508,PIC12F509 were supported and tested (added: 2005-02-06 JST)
RCD Programmer for the computers whitch have poor surge protection (added: 2005-02-06 JST)
Multi PIC Programmer 5V2 - An alternative version (added: 2005-02-06 JST)
I added Supported devices list (including known problems)...2004-12-19 JST

Disclaimer

The information on my site is published in the hope that it will be useful, but WITHOUT ANY WARRANTY. I shall have no liability to any person irrespective of the nation, for losses or damage arising from the use of the information contained on my site. The entire risk is with you.
Opinions and any other contents on my site are subject to change without notice.

E-mail to fngwfngATyahoo.co.jp

Last modified date:2006-07-16 JST

2004-03-06 JST